Grass Valley JEP Series v.1.3.0 - Manual (Page 40)

40 JEP Series — Installation Manual
Section 1 — JEP-100 Control Panel
Follow these steps to load the latest software onto the panels:
1. Start the Update Manager application. (Start>All Programs >Grass
Valley>Jep100 >UpdateManager) Any JEP-100 panels on the network
should be displayed.
The program will find the JEP-100 panels
Figure 17. The Update Manager Application
2. Select the panel and then click the Change IP button. The Change IP
Addresses dialog will then appear.
Note The IP Addresses shown in Figure 18 are used for example only. Enter your
Network settings.
Figure 18. The Change IP Addresses Dialog
3. Select the IP Address check box and then enter a free IP address on your
network.
4. Select and enter the information about your network in the field.
5. Click the OK button.
Double-click the
Displayed Panel
Enter 6 digit Serial # or the last
6 digits of the MAC address