Grass Valley JEP Series v.1.3.0 User Manual

Page 43

JEP Series — Installation Manual

Updating to the Latest Software Version

Note

This procedure will work if the Default IP address of the control panel is on
the same network as the computer. If the Default IP address is not, then you
will not be able to access the Panel Web page; in this case you will have to
use Netconfig's change IP tool to set the IP, Gateway, Mask, and Server IP
addresses. After changing the IP address, navigate to the Web page and set
the control panels device ID.

Follow these steps to reset the control panel's name and network settings:

Select the JEP-100 panel from the Navigation panel on the left side
(

Figure 22

). The JEP Panel page will appear on the right frame.

Figure 22. The Update Manager Application

Select the Panel Network link. The Panel Network Configuration page
will then appear.

Enter a name in the Panel Device name field.

Verify and modify the network settings as necessary.

Select the JEP-100
panel