Diag - diagnostic mode, C.b. - change brightness, Output button assignment – Grass Valley JEP Series v.1.3.0 User Manual
Page 83
JEP Series — Installation Manual
83
Diag - Diagnostic Mode
Provides a test of the LED character set and all button lamps. Exit this mode
by pressing
TAKE
or
CLEAR
.
Note
Buttons 65, 73, and 81 may not light while in Diagnostics mode. This is a
diagnostics code problem and does not affect the function of the panel.
C.B. - Change Brightness
Changes brightness of LEDs in display windows.
When "C.B. ?" is displayed, press the
TAKE
button; then use
UP/DOWN
to select
the preferred brightness level. Exit this mode by pressing
TAKE
or
CLEAR
.
Output Button Assignment
An Output button’s assignment can be made from the Jupiter configura-
tion. Any Output / Destination buttons assignment can now be defined.
See Section 5: The Configurator Application in the CM-4400 Jupiter manual
for the steps needed to make these assignments.
You will need to use the:
•
CPESEXTND type for the Output and Input button.
•
CP3800 type for Level and Sequences.
Figure 40. Input and Outputs CP Sets
CPESEXTND
Type