Grass Valley JEP Series v.1.3.0 - Manual (Page 35)

JEP Series — Installation Manual 35
Software Installation Process
Software Installation Process
JEP-100 series hardware panels are shipped with the current software
installed. There is no need to install panel software on newly shipping sys-
tems. However, the IP address must be set on each panel so it can operate
on the network. The NetConfig application is used to discover and set IP
addresses of the JEP-100 series panels. Once version 1.3.0 is installed, Net-
Config may also used to update JEP-100 series panel software, by transfer-
ring panel code from the computer running NetConfig directly to the
panels.
This section will describe the steps needed to Install the latest software on
the PC, Download the new firmware to the panel using the Network
Download Utility and Updating the panel using the Update Manager
application.
Note The Panels MUST be connected to a LAN connection during a software
upgrade session even if the panel is uses a Serial connection.
Installing the Latest Software Version to the PC
Follow these steps to begin installing the JEP-100 software:
1. Insert the supplied software CDROM into the computer’s CD Drive
and follow the prompts.
Note The CD should automatically start the installation process. If not, browse to
the CD, using Window Explorer, and then click the setup.exe icon.
The JEP-100 Welcome screen will then appear. The space requirements
will be gathered (
Figure 10 ).
Figure 10. JEP-100 Installer Welcome Screen