Grass Valley JEP Series v.1.3.0 - Manual (Page 65)

JEP Series — Installation Manual 65
Button-per-Level Mode Breakaway
This method assumes that the levels have been assigned to specific buttons.
1. LEVEL - ON.
Note In this mode, when using a subset of the 96 buttons on the left side of the
panel, the LEVEL button must always be ON for the Level but tons to be effec-
tive.
2. Toggle on/off the preferred level(s).
3. Select the preferred input:
• Press one of the button-per-source (BPS) keys on the left side of the
panel (which immediately completes the switch), or
• Toggle the SOURCE button ON and use the UP/DOWN buttons to find a
source in the Preset window. Press the TAKE button to complete the
switch. Toggling SOURCE to OFF will exit.
As long as LEVEL is ON , the panel will remember the breakaway level(s) pre-
viously selected and switch accordingly. When LEVEL is OFF , the panel will
revert to All Level switching.
Checking Status of Selected Level
Press CLEAR . With the LEVEL button ON , press UP/DOWN to step to the preferred
level. The status of the selected level will be shown in the Status window.