Grass Valley JEP Series v.1.3.0 - Manual (Page 52)

52 JEP Series — Installation Manual
Section 1 — JEP-100 Control Panel
In Panel - This column is not used for JEP-100 panels.
Out Set - Output Set name. If the entry is an actual CP Output Set, then the
control panel will be able to control all the outputs listed in that Set.
Depending on the con tents of the set, this would allow for full-matrix or
multi-bus control.
The panel now uses the CPEXTN type set. The panel now has the ability to
assign buttons as destinations, Using the output sets button field same as
the S100 panel.
The CP output set will have to be the CPESXTND type to work with the
newer features.
Alternatively, this field can be used to enter the name of a single switcher
output to be controlled. The source of the output name is the Switcher
Output table.
Out Panel - This column is not used for JEP-100 panels.
Level Set - Select the CP Level Set name. Select the CP3800 Level for the
panel to work with the newer features.
Override - Not used for JEP-100 panels.
Sequence - Now used for JEP-100 panels. Select a CP Sequence set name.
A Sequence set is used to execute a list of switches with a single command.