Grass Valley FT Server - Manual (Page 79)

13. On the Recover data page, under Where to recover, select the correct destination partition for
each source partition as follows:
a) Select Recover Disk 1 MBR .
The MBR Destination dialog box opens.
b) In the MBR Destination dialog box, select Disk 1: Seagate SCSI .
c) Click OK .
d) Select Recover System Reserved (C:) .
The Volume Selection dialog box opens.
e) In the Volume Selection dialog box, select Disk 1: Seagate SCSI .
f) Click OK .
g) Select Recover NTFS (C:) .
The Volume Selection dialog box opens.
h) In the Volume Selection dialog box, select Disk 1: Seagate SCSI .
i) Click OK .
j) Select Recover NTFS (D:) .
The Volume Selection dialog box opens.
k) In the Volume Selection dialog box, select Disk 1: Seagate SCSI .
l) Click OK .
14. On the Recover Data page, click OK .
The restore process begins.
15. On the My Recovery Details page, select the Progress tab to view the progress.
The image loads in approximately 9 minutes.
16. When the data is successfully restored, click OK .
17. Close all Acronis pages and the Acronis main window.
The machine restarts automatically.
18. Remove the recovery media while the machine is shutting down.
19. Wait until startup processes are complete on the top CPU/IO module. Leave the module running.
20. When prompted, enter the machine name.
Make sure the name is identical to the name it previously had.
After start up, one or more device discovery windows can open. Allow processes to complete
without interference.
At first start up after reimage, the system is in Embedded Security Update mode by default.
21. On the bottom CPU/IO module, connect AC power cabling. The module starts up.
Continue with the steps in the master task for restoring from a generic recovery disk image.
20131220 FT Server Instruction Manual 79
Servicing the FT Server