Grass Valley FT Server - Manual (Page 20)

NOTE: Installation will vary slightly according to whether there is an adapter on the front of
the rack. A standard EIA IT rack with no adapters is shown.
1. Remove the front unit containing the DVD drive and the LED module from the front of the
chassis by loosening the screw at the bottom of the unit and pulling it out.
2. At the rear of the chassis, remove the system backplane. Loosen the two thumb screws then move
the backplane slightly to the right and pull it straight out from the chassis.
3. Insert the empty chassis into the rack from the front.
4. Align the empty chassis so it is centered on the side rack mount rails.
20 FT Server Instruction Manual 20131220
FT Server Installation Information