Grass Valley FT Server User Manual
Page 39
By setting RDR, as the following figure and table show, dual configuration is set between the disks
of the corresponding slots and then these disks are recognized as one virtual disk by Windows (such
as Disk Management and Device Manager).
CAUTIONS: Read the following cautions before using the RDR Utility:
•
RDR can only be used on the disks inserted into the built-in slots of the FT server. It cannot be
used on the dynamic disk.
•
Be sure to use a basic disk as the system disk. Only a data disk can be used for a dynamic disk.
•
Be sure to specify RDR to all disks inserted in the built-in slots and make duplex settings.
•
Be sure to configure the RDR settings in the same way not only when the OS is installed but
also when the disk is added to the PCI module.
•
RDR can only be used on basic disks. If a span volume or stripe volume is needed, configure
RDR to a basic disk and then change the disk to a dynamic disk using
Disk Management
.
•
Before performing physical formatting, change
OS Boot Monitoring
to
Disabled
on
Server
Monitoring Configuration
in the BIOS setup utility.
20131220
FT Server Instruction Manual
39
Configuring the FT Server