Grass Valley FT Server - Manual (Page 48)

9. Verify that disk synchronization has started and the status of the DISK ACCESS LED and RDR
Utility display changes as shown in the table and the RDR Utility screen below.
RDR Utility DISK ACCESS LED During synchronization
Status Condition
N/A Online Green and blinking Synchronization source disk
N/A Syncing Amber and blinking Synchronization destination
disk
Resync X %
(x = 0, 4, 8, ...96)
Simplex N/A RDR Virtual disk
IMPORTANT:
• The time required for synchronization varies depending on the partition size on the disk. For
a 73GB partition, it takes about 80 minutes. When the partition does not exist on the disk, the
synchronization is completed immediately after the RDR is set, and Op State: State changes
to Duplex. However, when the dynamic disk is used, the time required for synchronization
depends on the disk size regardless of whether or not the partition exists on the disk.
• Setting dual disk configuration may not complete if you reboot the system during the
synchronization. Do not reboot the system before the synchronization process completes.
• If the system stops by improper termination of Windows such as pressing the Power button,
the entire synchronized disk area will be resynchronized after rebooting the system.
Verify that disk synchronization is complete by noting that the status of the DISK ACCESS LED
and RDR Utility display change as described in the table and RDR Utility screen below.
48 FT Server Instruction Manual 20131220
Configuring the FT Server