Grass Valley FT Server - Manual (Page 78)

6. Do the following:
a) Insert the Recovery CD.
b) Restart the machine.
If there is a problem restarting, hold the standby button down for five seconds to force a hard
shutdown. Then press the standby button again to startup.
The system boots from the Recovery CD.
The Acronis program loads.
7. On the Acronis Rescue Media page, do the following:
a) Use the keyboard arrow keys to select Acronis Backup and Recovery 11.5 (64-bit...) and then
press Enter .
b) Wait while Acronis fully loads.
This can take a few minutes. When loaded, the Acronis Backup and Recovery page opens
and displays a mouse cursor.
c) Connect the mouse to the USB port.
NOTE: A problem with Acronis 11.5 on the FT server requires this workaround. The mouse
must be temporarily disconnected before booting into Acronis, then reconnected after Acronis
fully loads.
8. On the Acronis Backup and Recovery page, select Recover .
The Recover Data page opens
9. On the Recover Data page, under What to Recover page, select Select Data .
The Data to Recover Selection dialog box opens.
10. On the Data to Recover Selection dialog box, do the following:
a) Select Browse .
b) In the tree view, select the USB drive that contains the generic recovery disk image.
Even though your backup is on the drive, it is not yet visible.
c) Click OK .
On the Archive View tab, your backup name is listed.
11. On the Archive View tab, select your backup.
12. Under Backup contents, do the following:
a) Select MBR .
b) Select Basic .
This selects all drives.
c) Click OK .
The Data to Recover Selection dialog box closes.
78 FT Server Instruction Manual 20131220
Servicing the FT Server