Grass Valley Branding Panel - Manual (Page 39)

RCP-BR: Guide to Installation and Operation
Miranda Technologies Inc. Page 31
The current state of the keyer is indicated by the button. If the button is lit red
then the keyer is currently cut up.
Once the keyer is armed, to carry out the armed action, press the ‘Take’ button
which will be flashing red to indicate that an item is armed.
3.5.2 Setting fade rates
The fade rate for the DSK transition can be set in fields from 0-100. To set the
rate it is necessary to switch to the DSK Setup panel. To get to the DSK Setup
panel the DSK Media panel should be selected first. To open this panel press on
the DSK label above the DSK. Once in the DSK Media panel, the Setup panel
can be selected by pressing the Setup button in the top row. This will open the
panel shown in figure 3-10.
Figure 3-10 DSK Setup panel
To adjust the DSK fade rate adjust the top right hand rotary, turning clockwise
increases the delay and anti-clockwise decreases the delay.