Grass Valley Aurora Ingest v.7.0.0 - Manual (Page 94)

A drop-down list displays the available commands.
5. Select a command to apply to this key.
6. Repeat steps 4 and 5 to configure additional keys.
7. Once you have finished configuring those keys, click OK .
Using the X-keys Jog/Shuttle Controller
The X-keys controller allows you to simplify your workflow. For example, you can
just press customized keys to easily preview and edit assets within video viewer
windows.
Any commands you send using the X-keys controller apply to the currently active
window, which is considered to have
focus . When the window has focus, you can
perform tasks such as navigating through a clip or trimming a clip. Always bear in
mind that you need to give focus to a window before you can apply the X-keys
controller commands to it.
The following table describes the functionalities of keys that can be customized for
your X-keys Jog/Shuttle controller. Some of these keys had been pre-configured on
the Green layer. If necessary, you can configure more keys either on the Green layer
or the Red layer.
Description Setting
Indicates whether you are configuring the Red or Green layer. Layer
Resets all the keys on the particular layer that you are configuring. Reset
All Keys does not affect keys that shift between the layers, i.e. the Toggle,
Red, and Green keys. Reset All Keys
Jogs the clip backward 1 frame. 1 Back
Jogs the clip forward 1 frame. 1 Fwd
Jogs the clip backward 10 frames. 10 Back
Jogs the clip forward 10 frames. 10 Fwd
Plays or stops the clip. Play/Stop
Plays a clip from the start. Play St
Marks a new In point for a clip. Mark In
Clears the In point of a clip. Clear In
Goes to the In point of a clip. Goto In
Marks a new Out point for a clip. Mark Out
94 Aurora Ingest System Guide 14 April 2010
Configuring Aurora Ingest