Grass Valley Aurora Ingest v.7.0.0 - Manual (Page 171)

With the Live Feed Viewer, you can view an incoming video feed as it is recording,
add metadata to the feed and crash record events directly from the Live Feed Viewer
window.
With the Asset Viewer, you can view previously recorded high-resolution clips and
trim the top and tail of a clip if it is already linked to an Aurora Playout placeholder.
You can also view low-resolution clips via the Asset Proxy Viewer, add metadata and
trim those proxies if needed.
Both Live Feed Viewer and Asset Viewer buttons are easily accessible on the toolbar
of Scheduler.
Using Live Feed Viewer
The Live Feed Viewer or also known as Live Previewer can be used to monitor the
recording of an event, add metadata to the event, crash record an event directly from
the viewer window and trimming of assets.
You need to enable the feature in the video viewer tab within Tools | Options of the
Scheduler.
If you have a router configured in your system, you can setup the router source for
the Live Previewer in the video viewer tab within Tools | Options of the Scheduler.
You do not need to have a video capture card installed in order to use this feature.
You can set the Video Display Device drop-down to No Capture Device and configure
your router source to an external monitor to preview the feed.
1. Click the Live Feed Viewer icon or select View | Live Feed Viewer .
The Live Feed Viewer window opens to the bottom half of the Scheduler
interface.
2. You can set details of an event and start a crash record by clicking the Record
button within the window.
As the recording starts, you can view the incoming feed and also add metadata
for the feed within the right portion of the Live Previewer window.
14 April 2010 Aurora Ingest System Guide 171
Using Aurora Ingest - Scheduler