Grass Valley Aurora Ingest v.7.0.0 - Manual (Page 100)

After you have successfully added the VTR, you should see it displayed in the
VTR Status window with a green indicator next to its name.
Once you have added VTRs, you can modify or delete them. However, if you only
have one VTR displayed in the status window, you cannot delete it and have an empty
status window.
Troubleshooting VTR Controller configuration
If you see a red indicator next to the VTR’s name, try restarting VTR Controller.
If the VTR status still displays a red indicator, verify the following:
• Check your VTR Ingest configuration and make sure the VTR information matches
the information you entered when configuring VTR Controller.
• The correct COM port has been specified for the VTR.
• The COM port is not being used by another application controlling the VTR.
• The VTR is turned on.
• The hardware has been correctly installed.
• The IP address or computer name where VTR Controller is installed matches the
address or name in the VTR Ingest application.
Configuring VTR Ingest application
You need to configure the VTR Ingest application before using it.
100 Aurora Ingest System Guide 14 April 2010
Configuring Aurora Ingest