Hd/sd criteria web page – Grass Valley 8972PX User Manual
Page 58
58
8972PX — Instruction Manual
Configuration
HD/SD Criteria Web Page
Use
this
link
Use the HD/SD Criteria web page (
) to set up the cri-
teria for determining whether a signal is good or not good. This example
illustrates an EDH error where EDH/CRC Errors are not part of the criteria.
Valid Signal Criteria
This section lists the criteria always enabled for determining signal health.
These criteria cannot be disabled. For an overview of these criteria, refer to
To use EDH/CRC Errors as part of signal health criteria, select the EDH/
CRC Errors
Enable
checkbox.
EDH/CRC Threshold
If EDH/CRC Errors checkbox has been selected, use this section to set the
amount of erroneous fields and erroneous total fields that the module will
allow an EDH/CRC error to occur before reporting an error. This setting
applies at all input signals, Primary, Secondary, and Alternate.
Error Reporting
If an error has been detected, it will be reported next to the signal name
(
Errors
). Use the corresponding
Reset
button to reset the error log and see if
the signal has recovered. If there are no errors the status will report
None
.
Reset All Button
Use the
Reset All
button to reset all three error counters.