H3C Technologies H3C SecBlade LB Cards - Manual (Page 79)

71
and cannot be used for packet forwarding. The VF corresponding to MAC address
000f-e2ff-4011 on LB C becomes the AVF, and LB C takes over LB A for packet forwarding.
# When the timeout timer (about 1800 seconds) expires, display the detailed information about
VRRP group 1 on LB C.
[LBC-GigabitEthernet0/1] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Mode : Load Balance
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface GigabitEthernet0/1
VRID : 1 Adver Timer : 100
Admin Status : Up State : Backup
Config Pri : 100 Running Pri : 100
Preempt Mode : Yes Delay Time : 5
Become Master : 4200ms left
Auth Type : None
Virtual IP : FE80::10
1::10
Member IP List : FE80::3 (Local, Backup)
FE80::1 (Master)
FE80::2 (Backup)
Forwarder Information: 2 Forwarders 1 Active
Config Weight : 255
Running Weight : 255
Forwarder 02
State : Listening
Virtual MAC : 000f-e2ff-4012 (Learnt)
Owner ID : 0000-5e01-1103
Priority : 127
Active : FE80::2
Forwarder 03
State : Active
Virtual MAC : 000f-e2ff-4013 (Owner)
Owner ID : 0000-5e01-1105
Priority : 255
Active : local
Forwarder Weight Track Information:
Track Object : 1 State : Positive Weight Reduced : 250
The output shows that when the timeout timer expires, the VF corresponding to virtual MAC
address 000f-e2ff-4011 is removed, and no longer forwards the packets destined for the MAC
address.
# When LB A fails, use the display vrrp ipv6 verbose command to display the detailed information
about VRRP group 1 on LB B.
[LBB-GigabitEthernet0/1] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Mode : Load Balance
Run Method : Virtual MAC
Total number of virtual routers : 1