H3C Technologies H3C SecBlade LB Cards - Manual (Page 125)

117
Step Command Remarks
2. Create an NQA operation and
enter NQA operation view. nqa entry admin-name
operation-tag
By default, no NQA operation is created.
3. Specify the SNMP type and
enter its view.
type snmp N/A
4. Configure the destination
address of SNMP packets.
destination ip
ip-address By default, no destination IP address is
configured.
5. Specify the source port of SNMP
packets.
source port
port-number
Optional.
By default, no source port number is
specified.
6. Configure the source IP address
of SNMP packets.
source ip ip-address
Optional.
By default, no source IP address is specified.
The source IP address must be the IP address
of a local interface. The local interface must
be up. Otherwise, no SNMP packets can be
sent out.
Configuring a TCP operation
A TCP operation measures the time the NQA client uses to establish a TCP connection to a specific port
on the NQA server.
The TCP operation requires both the NQA server and the NQA client. Before you perform a TCP
operation, configure a TCP listening service on the NQA server. For more information about the TCP
listening service configuration, see " Configuring the NQA server ."
To configure a TCP operation:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create an NQA operation
and enter NQA operation
view.
nqa entry admin-name
operation-tag
By default, no NQA operation is created.
3. Specify the TCP type and
enter its view.
type tcp N/A
4. Configure the destination
address of TCP packets.
destination ip ip-address
By default, no destination IP address is
configured.
The destination address must be the same as
the IP address of the listening service
configured on the NQA server.
5. Configure the destination port
of TCP packets.
destination port
port-number
By default, no destination port number is
configured.
The destination port number must be the
same as that of the listening service on the
NQA server.