H3C Technologies H3C SecBlade LB Cards - Manual (Page 23)

15
Configuring IPv4 VRRP
Configuring IPv4 VRRP in the Web interface
Recommended configuration procedure
Step Remarks
1. Creating a VRRP group
Required.
Create a VRRP group on a VRRP interface and configure the virtual IP
address.
IMPORTANT:
• Before creating a VRRP group on an interface, you should first configure
an IP address for the interface and make sure that the virtual IP address
to be configured is in the same network segment as the IP address of the
interface.
• You can configure a maximum of 16 VRRP groups on an interface and a
maximum of 16 virtual IP addresses in a VRRP group.
2. Configuring a VRRP group
Optional.
Configure router priority, preemption mode, authentication mode, packet
attributes, and tracking function of the VRRP group.
Creating a VRRP group
1. Select High Reliability > VRRP from the navigation tree.
The VRRP interfaces page appears.
Figure 11 VRRP interfaces page
2. Click the icon corresponding to the interface to be configured.
The VRRP group page appears.