H3C Technologies H3C SecBlade LB Cards - Manual (Page 34)

26
Step Command Remarks
2. Enable the trap function for
VRRP. snmp-agent trap enable vrrp
[ authfailure | newmaster ]
Optional.
By default, the trap function for VRRP is
enabled.
For more information about the
command, see the snmp-agent trap
enable command in System Maintenance
Command Reference.
Displaying and maintaining IPv4 VRRP
Task Command Remarks
Display VRRP group
status.
display vrrp [ verbose ] [ interface interface-type
interface-number [ vrid virtual-router-id ] ] [ | { begin |
exclude | include } regular-expression ]
Available in any view.
Display VRRP group
statistics.
display vrrp statistics [ interface interface-type
interface-number [ vrid virtual-router-id ] ] [ | { begin |
exclude | include } regular-expression ]
Available in any view.
Clear VRRP group
statistics. reset vrrp statistics [ interface interface-type
interface-number [ vrid virtual-router-id ] ] Available in user
view.
Configuring IPv6 VRRP
IPv6 VRRP can be configured only at the CLI.
IPv6 VRRP configuration task list
Task Remarks
Configuring a VRRP working mode Optional.
Specifying the type of MAC addresses mapped to virtual IPv6
addresses
Optional.
This configuration does not apply to VRRP
load balancing mode.
Creating a VRRP group and configuring a virtual IPv6 address Required.
Configuring router priority, preemptive mode and tracking
function
Optional.
Configuring VF tracking
Optional.
This configuration applies to only VRRP load
balancing mode.
Configuring VRRP packet attributes Optional.