H3C Technologies H3C SecBlade LB Cards - Manual (Page 105)

97
Figure 43 Network diagram
Configuration procedure
1. Configure the IP address of each interface as shown in Figure 43 . (Details not shown.)
2. Configure an NQA test group on LB A:
# Create an NQA test group with the administrator name admin and the operation tag test.
system-view
[LBA] nqa entry admin test
# Configure the test type as ICMP echo test.
[LBA-nqa-admin-test] type icmp-echo
# Configure the destination address as 10.1.2.2.
[LBA-nqa-admin-test-icmp-echo] destination ip 10.1.2.2
# Configure the interval between two consecutive tests as 100 milliseconds.
[LBA-nqa-admin-test-icmp-echo] frequency 100
# Create reaction entry 1, specifying that five consecutive probe failures trigger the Track module.
[LBA-nqa-admin-test-icmp-echo] reaction 1 checked-element probe-fail threshold-type
consecutive 5 action-type trigger-only
[LBA-nqa-admin-test-icmp-echo] quit
# Start the NQA test.
[LBA] nqa schedule admin test start-time now lifetime forever
3. Configure a track entry on LB A:
# Configure track entry 1, and associate it with reaction entry 1 of the NQA test group (with the
administrator admin, and the operation tag test).
[LBA] track 1 nqa entry admin test reaction 1
4. Configure VRRP on LB A:
# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[LBA] interface gigabitethernet0/1
[LBA-GigabitEthernet0/1] vrrp vrid 1 virtual-ip 10.1.1.10
# Set the priority of LB A in VRRP group 1 to 110.
[LBA-GigabitEthernet0/1] vrrp vrid 1 priority 110
# Set the authentication mode of VRRP group 1 to simple, and the authentication key to hello.