H3C Technologies H3C SecBlade LB Cards - Manual (Page 113)

105
Figure 45 Network diagram
Configuration procedure
1. Configure the IP address of each interface as shown in Figure 45 . (Details not shown.)
2. Configure a track entry on LB A:
# Configure track entry 1, and associate it with the physical status of the uplink interface
GigabitEthernet 0/2.
[LBA] track 1 interface gigabitethernet 0/2
3. Configure VRRP on LB A:
# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[LBA] interface gigabitethernet0/1
[LBA-GigabitEthernet0/1] vrrp vrid 1 virtual-ip 10.1.1.10
# Set the priority of LB A in VRRP group 1 to 110.
[LBA-GigabitEthernet0/1] vrrp vrid 1 priority 110
# Configure to monitor track entry 1 and specify the priority decrement as 30.
[LBA-GigabitEthernet0/1] vrrp vrid 1 track 1 reduced 30
4. Configure VRRP on LB B:
system-view
[LBB] interface gigabitethernet0/1
# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[LBB-GigabitEthernet0/1] vrrp vrid 1 virtual-ip 10.1.1.10
Verifying the configuration
After configuration, ping Host B on Host A, and you can see that Host B is reachable. Use the
display vrrp command to view the configuration result.
# Display detailed information about VRRP group 1 on LB A.
[LBA-GigabitEthernet0/1] display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface GigabitEthernet0/1