H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 99)

90
To do…
Use the
command…
Remarks
Enter interface
view or port
group view
Enter Ethernet
interface view
interface
interface-type
interface-number
Required
Use any command.
• The configuration made in Ethernet interface
view applies only to the port.
• The configuration made in port group view
applies to all ports in the port group.
• The configuration made in Layer 2 aggregate
interface view applies to the aggregate
interface and its aggregation member ports.
If the system fails to apply the configuration to
the aggregate interface, it stops applying the
configuration to aggregation member ports.
If the system fails to apply the configuration to
an aggregation member port, it skips the port
and moves to the next member port.
Enter Layer 2
aggregate
interface view
interface
bridge-aggregation
interface-number
Enter port
group view port-group manual
port-group-name
Configure the link type of the ports
as access
port link-type access
Optional
By default, all ports are access ports.
Assign the access ports to a VLAN
port access vlan
vlan-id Optional
By default, all access ports belong to VLAN 1.
NOTE:
•
Before assigning an access port to a VLAN, create the VLAN first.
• In VLAN view, only Layer 2 Ethernet interfaces can be assigned to the VLAN.
Assigning a trunk port to a VLAN
A trunk port can carry multiple VLANs. You can assign it to a VLAN in interface view (including Ethernet
interface view, Layer 2 aggregate interface view, and port group view.
Follow these steps to assign a trunk port to one or multiple VLANs:
To do… Use the command… Remarks
Enter system view system-view —