Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 46

•

Device A and Device B are connected through their respective Layer 2 Ethernet interfaces

GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3.

•

Configure a Layer 2 dynamic aggregation group on Device A and Device B respectively, enable
VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other end, and

VLAN 20 at one end to communicate with VLAN 20 at the other end.

•

Enable traffic to be load-shared across aggregation group member ports based on source and
destination MAC addresses.

Figure 8 Network diagram for Layer 2 dynamic aggregation

Configuration procedure

Configure Device A

# Create VLAN 10, and assign the port GigabitEthernet 1/0/4 to VLAN 10.

system-view

[DeviceA] vlan 10

[DeviceA-vlan10] port gigabitethernet 1/0/4

[DeviceA-vlan10] quit

# Create VLAN 20, and assign the port GigabitEthernet 1/0/5 to VLAN 20.

[DeviceA] vlan 20

[DeviceA-vlan20] port gigabitethernet 1/0/5

[DeviceA-vlan20] quit

# Create Layer 2 aggregate interface Bridge-Aggregation 1, and configure the link aggregation mode
as dynamic.

[DeviceA] interface bridge-aggregation 1

[DeviceA-Bridge-Aggregation1] link-aggregation mode dynamic

[DeviceA-Bridge-Aggregation1] quit

# Assign ports GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3 to link aggregation group 1 one
at a time.

[DeviceA] interface gigabitethernet 1/0/1

[DeviceA-GigabitEthernet1/0/1] port link-aggregation group 1

[DeviceA-GigabitEthernet1/0/1] quit

[DeviceA] interface gigabitethernet 1/0/2

[DeviceA-GigabitEthernet1/0/2] port link-aggregation group 1

[DeviceA-GigabitEthernet1/0/2] quit