H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 101)

92
To do… Use the command… Remarks
Enter interface
view or port
group view
Enter Ethernet
interface view interface interface-type
interface-number
Required
Use any command.
• The configuration made in Ethernet
interface view applies only to the
port.
• The configuration made in port
group view applies to all ports in the
port group.
• The configuration made in Layer 2
aggregate interface view applies to
the aggregate interface and its
aggregation member ports. If the
system fails to apply the
configuration to the aggregate
interface, it stops applying the
configuration to aggregation
member ports. If the system fails to
apply the configuration to an
aggregation member port, it skips
the port and moves to the next
member port.
Enter Layer 2
aggregate
interface view
interface bridge-aggregation
interface-number
Enter port
group view port-group manual
port-group-name
Configure the link type of the
ports as hybrid
port link-type hybrid
Required
By default, all ports are access ports.
Assign the hybrid ports to the
specified VLANs port hybrid vlan vlan-id-list
{ tagged | untagged }
Required
By default, a hybrid port allows only
packets of VLAN 1 to pass through
untagged.
Configure the PVID of the hybrid
ports
port hybrid pvid vlan vlan-id
Optional
By default, the PVID is VLAN 1.
NOTE:
•
To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to access
first.
• When you use the port link-type { access | hybrid | trunk } command to change the link type of a port,
the loopback-detection action configuration is restored to the default. For more information about the
loopback-detection action command, see the
Layer 2 Command Reference.
• Before assigning a hybrid port to a VLAN, create the VLAN first.
• After configuring the PVID for a hybrid port, you must use the port hybrid vlan command to configure
the hybrid port to allow packets from the PVID to pass through, so that the egress port can forward
packets from the PVID.
Port-based VLAN configuration example
Network requirements
As shown in Figure 27 :