H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 41)

32
Configuring an aggregate interface
NOTE:
In addition to the preceding configurations, most of the configurations that can be performed on Ethernet
interfaces can also be performed on aggregate interfaces.
Configuring the description of an aggregate interface
You can configure the description of an aggregate interface for administration purposes such as
describing the purpose of the interface.
Follow these steps to configure the description of an aggregate interface:
To do... Use the command... Remarks
Enter system view system-view —
Enter Layer 2 aggregate
interface view interface bridge-aggregation
interface-number
Required
Configure the description of the
aggregate interface
description text
Optional
By default, the description of an
interface is in the format of
interface-name Interface, such as
Bridge-Aggregation1 Interface.
Enabling link state traps for an aggregate interface
You can configure an aggregate interface to generate linkUp trap messages when its link goes up and
linkDown trap messages when its link goes down. For more information, see the Network Management
and Monitoring Configuration Guide.
Follow these steps to enable link state traps on an aggregate interface:
To do... Use the command... Remarks
Enter system view system-view —
Enable the trap function
globally snmp-agent trap enable [ standard
[ linkdown | linkup ] * ]
Optional
By default, link state trapping is
enabled globally and on all
interfaces.
Enter Layer 2 aggregate
interface view interface bridge-aggregation
interface-number
Required
Enable link state traps for the
aggregate interface
enable snmp trap updown
Optional
Enabled by default.