H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 111)

102
To do… Use the command… Remarks
Enter interface
view or port
group view
Enter Ethernet
interface view interface interface-type
interface-number
Required
Use any command.
• The configuration made in
Ethernet interface view applies
only to the port.
• The configuration made in port
group view applies to all ports in
the port group.
• The configuration made in Layer 2
aggregate interface view applies
to the aggregate interface and its
aggregation member ports. If the
system fails to apply the
configuration to the aggregate
interface, it stops applying the
configuration to aggregation
member ports. If the system fails to
apply the configuration to an
aggregation member port, it skips
the port and moves to the next
member port.
Enter Layer 2
aggregate
interface view
interface bridge-aggregation
interface-number
Enter port group
view port-group manual
port-group-name
Configure the port link type as
hybrid
port link-type hybrid
Required
By default, all ports are access ports.
Assign the hybrid port to the
specified protocol-based VLANs port hybrid vlan vlan-id-list
{ tagged | untagged }
Required
By default, a hybrid port is only in
VLAN 1.
Assign the protocol template you
have created to the hybrid port
port hybrid protocol-vlan vlan
vlan-id { protocol-index [ to
protocol-end ] | all }
Required
CAUTION:
•
In the protocol-vlan command, do not set the dsap-id argument and the ssap-id argument to 0xe0
(which corresponds to the ipx llc protocol template) or 0xff (which corresponds to the ipx raw protocol
template) at the same time.
• When you use the mode keyword to configure a protocol-based VLAN, do not set the etype-id
argument of ethernetii packets to 0x0800, 0x8137, 0x809b, and 0x86dd, which correspond to ipv4,
ipx, appletalk, and ipv6 protocol templates.
• A protocol-based VLAN processes only untagged inbound packets, whereas the voice VLAN in
automatic mode processes only tagged voice traffic. Do not configure a VLAN as both a protocol-based
VLAN and a voice VLAN.
Protocol-based VLAN configuration example
Network requirements
In a lab environment, as shown in Figure 30 , most hosts run the IPv4 protocol, and the rest of the hosts
run the IPv6 protocol for teaching purpose. To avoid interference, isolate IPv4 traffic and IPv6 traffic at
Layer 2.