H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 112)

103
Figure 30 Network diagram for protocol-based VLAN configuration
Configuration consideration
Create VLANs 100 and 200. Associate VLAN 100 with IPv4, and VLAN 200 with IPv6. Configure
protocol-based VLANs to isolate IPv4 traffic and IPv6 traffic at Layer 2.
Configuration procedure
1. Configuration on Device
# Create VLAN 100, and assign port GigabitEthernet 1/0/11 to VLAN 100.
system-view
[Device] vlan 100
[Device-vlan100] description protocol VLAN for IPv4
[Device-vlan100] port gigabitethernet 1/0/11
[Device-vlan100] quit
# Create VLAN 200, and assign port GigabitEthernet 1/0/12 to VLAN 200.
[Device] vlan 200
[Device-vlan200] description protocol VLAN for IPv6
[Device-vlan200] port gigabitethernet 1/0/12
# Create an IPv6 protocol template in the view of VLAN 200, and an IPv4 protocol template in the view
of VLAN 100.
[Device-vlan200] protocol-vlan 1 ipv6
[Device-vlan200] quit
[Device] vlan 100
[Device-vlan100] protocol-vlan 1 ipv4
[Device-vlan100] quit
# Configure port GigabitEthernet 1/0/1 as a hybrid port that forwards packets of VLANs 100 and 200
untagged.
[Device] interface gigabitethernet 1/0/1