beautypg.com

Network requirements, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 137

background image

128

# Create VLAN 3 (a static VLAN).

[DeviceB] vlan 3

[DeviceB-vlan3] quit

3.

Verify the configuration

Use the display gvrp local-vlan command to display the local VLAN information maintained by GVRP on

ports. For example:
# Display the local VLAN information maintained by GVRP on port GigabitEthernet 1/0/1 of Device A.

[DeviceA] display gvrp local-vlan interface gigabitethernet 1/0/1

Following VLANs exist in GVRP local database:

1(default), 2

According to the output, information about VLAN 1 and static VLAN information of VLAN 2 on the local
device are registered through GVRP, but dynamic VLAN information of VLAN 3 on Device B is not.
# Display the local VLAN information maintained by GVRP on port GigabitEthernet 1/0/1 of Device B.

[DeviceB] display gvrp local-vlan interface gigabitethernet 1/0/1

Following VLANs exist in GVRP local database:

1(default), 3

According to the output, information about VLAN 1 and static VLAN information of VLAN 3 on the local
device are registered through GVRP, but dynamic VLAN information of VLAN 2 on Device A is not.

GVRP forbidden registration mode configuration example

Network requirements

As shown in

Figure 39

,

Device A and Device B are connected through their ports GigabitEthernet 1/0/1.

Enable GVRP and configure the forbidden registration mode on ports to prevent the registration and
deregistration of all VLANs but VLAN 1 between the two devices.

Figure 39 Network diagram for GVRP forbidden registration mode configuration

Configuration procedure

1.

Configure Device A

# Enable GVRP globally.

system-view

[DeviceA] gvrp

# Configure port GigabitEthernet 1/0/1 as a trunk port, and assign it to all VLANs.

[DeviceA] interface gigabitethernet 1/0/1

[DeviceA-GigabitEthernet1/0/1] port link-type trunk

[DeviceA-GigabitEthernet1/0/1] port trunk permit vlan all

# Enable GVRP on GigabitEthernet 1/0/1, and set the GVRP registration mode to forbidden on the port.

[DeviceA-GigabitEthernet1/0/1] gvrp

[DeviceA-GigabitEthernet1/0/1] gvrp registration forbidden