H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 39)

30
Table 6 Features incompatible with Layer 2 aggregation groups
Feature Reference
MAC authentication MAC authentication in the Security Configuration Guide
Port security Port security in the Security Configuration Guide
IP source guard IP source guard in the Security Configuration Guide
802.1X 802.1X in the Security Configuration Guide
CAUTION:
Removing an aggregate interface also removes the corresponding aggregation group. At the same time,
all member ports leave the aggregation group.
Configuring a static aggregation group
NOTE:
To guarantee a successful static aggregation, make sure that the ports at both ends of each link are in the
same aggregation state.
Follow these steps to configure a Layer 2 static aggregation group:
To do... Use the command... Remarks
Enter system view system-view —
Create a Layer 2 aggregate
interface and enter Layer 2
aggregate interface view
interface bridge-aggregation
interface-number
Required
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
Exit to system view quit —
Enter Layer 2 Ethernet interface
view interface interface-type
interface-number Required
Repeat these two steps to assign
more Layer 2 Ethernet interfaces to
the aggregation group.
Assign the Ethernet interface to the
aggregation group port link-aggregation group
number
Assign the port an aggregation
priority link-aggregation port-priority
port-priority
Optional
By default, the aggregation priority
of a port is 32768.
Changing the aggregation priority
of a port may affect the
aggregation state of the ports in
the static aggregation group.