H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 145)

136
Task Remarks
Configuring CDP compatibility Optional
Configuring LLDP trapping Optional
NOTE:
LLDP-related configurations made in Ethernet interface view take effect only on the current port, and those
made in port group view take effect on all ports in the current port group.
Performing basic LLDP configuration
Enabling LLDP
To make LLDP take effect on specific ports, you must enable LLDP both globally and on these ports.
Follow these steps to enable LLDP:
To do… Use the command… Remarks
Enter system view system-view —
Enable LLDP globally lldp enable
Required
Enabled by default.
Enter Ethernet
interface view
or port group
view
Enter Layer 2 Ethernet
interface view interface interface-type
interface-number
Required
Use either command.
Enter port group view
port-group manual
port-group-name
Enable LLDP lldp enable
Optional
By default, LLDP is enabled on a port.
Setting the LLDP operating mode
LLDP can operate in one of the following modes.
• TxRx mode. A port in this mode sends and receives LLDPDUs.
• Tx mode. A port in this mode only sends LLDPDUs.
• Rx mode. A port in this mode only receives LLDPDUs.
• Disable mode. A port in this mode does not send or receive LLDPDUs.
Follow these steps to set the LLDP operating mode:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet
interface view
or port group
view
Enter Layer 2 Ethernet
interface view interface interface-type
interface-number
Required
Use either command.
Enter port group view port-group manual port-group-name