H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 42)

33
Shutting down an aggregate interface
Shutting down or bringing up an aggregate interface affects the aggregation state and link state of ports
in the corresponding aggregation group in the following ways:
• When an aggregate interface is shut down, all Selected ports in the corresponding aggregation
group become unselected and their link state becomes down.
• When an aggregate interface is brought up, the aggregation state of ports in the corresponding
aggregation group is recalculated and their link state becomes up.
Follow these steps to shut down an aggregate interface:
To do... Use the command... Remarks
Enter system view system-view —
Enter Layer 2 aggregate interface
view interface bridge-aggregation
interface-number
Required
Shut down the aggregate interface shutdown
Required
By default, aggregate interfaces
are up.
Configuring load sharing for link aggregation
groups
You can determine how traffic is load-shared in a link aggregation group by configuring load sharing
criteria. The criteria can be MAC addresses, service port numbers, IP addresses, or any combination.
Follow these steps to configure the global link-aggregation load sharing criteria:
To do... Use the command... Remarks
Enter system view system-view —
Configure the global
link-aggregation load sharing
criteria
link-aggregation load-sharing mode
{ destination-ip | destination-mac |
destination-port | source-ip |
source-mac | source-port } *
Required
Source/destination MAC address
for Layer 2 packets;
source/destination MAC address
and source/destination IP address
for Layer 3 packets.