H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 99)

90
# Configure the aggregate interface on AC as a trunk port, and configure it to allow packets from
VLAN 2, VLAN 3, and VLAN 10 to pass.
[AC]interface Bridge-Aggregation 1
[AC-Bridge-Aggregation1] port link-type trunk
[AC-Bridge-Aggregation1] port trunk permit vlan 2 3 10
[AC-Bridge-Aggregation1]quit
# Log in to the configuration interface of the switching engine from the AC engine using the oap
command, and enable IGMP snooping globally. Create VLAN 10, assign GigabitEthernet 1/0/1
to this VLAN, and enable IGMP snooping in this VLAN.
oap connect slot 0
Press CTRL+K to quit.
Connected to OAP!
User interface aux0 is available.
Press ENTER to get started.
system-view
[Device] igmp-snooping
[Device] vlan 10
[Device-vlan10] port GigabitEthernet 1/0/1
[Device-vlan10] igmp-snooping enable
[Device-vlan10] quit
# Configure GigabitEthernet 1/0/2 as a hybrid port, and configure it to allow packets from VLAN
2, VLAN 3, and VLAN 10 to pass.
[Device]interface GigabitEthernet 1/0/2
[Device-GigabitEthernet1/0/2] port link-type hybrid
[Device-GigabitEthernet1/0/2] port hybrid vlan 2 3 10 tagged
[Device-GigabitEthernet1/0/2] quit
# Use Ctrl + K to return to the configuration interface of the AC engine.
# Create VLAN 10, assign GigabitEthernet 1/0/1 to VLAN 10, and enable IGMP snooping in this
VLAN.
[AC] vlan 10
[AC-vlan10] port GigabitEthernet 1/0/1
[AC-vlan10] igmp-snooping enable
[AC-vlan10] quit
# Configure VLAN 2, VLAN 3, and WLAN-ESS 1 on AC. Configure WLAN-ESS 1 as a hybrid port
that permits packets from VLAN 2, VLAN 3, and VLAN 10 to pass and untags the packets.
Configure VLAN 10 as the default VLAN.
[AC] vlan 2
[AC-vlan2] vlan 3
[AC-vlan3] quit
[AC] interface WLAN-ESS 1
[AC-WLAN-ESS1] port link-type hybrid
[AC-WLAN-ESS1] port hybrid pvid vlan 10
[AC-WLAN-ESS1] port hybrid vlan 2 3 10 untagged
[AC-WLAN-ESS1] mac-vlan enable
# Configure the MAC-based VLAN feature so that Client A and Client B belong to VLAN 2 and
VLAN 3 respectively.