H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 75)

66
3. Verify the configuration:
# Display detailed MLD snooping group information in VLAN 100 on AC.
[AC]display mld-snooping group vlan 100 verbose
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, A-Aggregation port, C-Copy port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):100.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 0 port.
IP group(s):the following ip group(s) match to one mac group.
IP group address:FF1E::1
(::, FF1E::1):
Attribute: Host Port
Host port(s):total 1 port.
WLAN-DBSS1:0 (D)
The output shows that WLAN-DBSS 1:0 on AC joins the IPv6 multicast group FF1E::1.
Configuration procedure (for the WX6000 access controller modules other than the WX6103)
1. Configure WLAN services:
# Log into the configuration interface of a WX6000 access controller module other than the
WX6103 from the switch.
oap connect slot 2
Press CTRL+K to quit.
Connected to OAP!
User interface aux0 is available.
Press ENTER to get started.
system-view
# Configure WLAN-ESS interface 1 and assign it to VLAN 100.
[AC]Vlan 100
[AC-vlan100]quit
[AC]interface WLAN-ESS 1
[AC-WLAN-ESS1]port access vlan 100
[AC-WLAN-ESS1]quit
# Configure a WLAN service template with its SSID as multicast and authentication method as
open-system. Bind the WLAN-ESS interface with the service template.
[AC]wlan service-template 1 clear
[AC-wlan-st-1]ssid Multicast
[AC-wlan-st-1]bind WLAN-ESS 1
[AC-wlan-st-1]authentication-method open-system
[AC-wlan-st-1]service-template enable
[AC-wlan-st-1]quit