H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 81)

72
system-view
[AC] mld-snooping
[AC-mld-snooping] quit
# Create VLAN 100, assign ports GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 to this
VLAN, and enable MLD snooping and MLD snooping proxying in the VLAN.
[AC] vlan 100
[AC-vlan100] port gigabitethernet 1/0/1 gigabitethernet 1/0/2
[AC-vlan100] mld-snooping enable
[AC-vlan100] mld-snooping proxying enable
[AC-vlan100] quit
# Configure WLAN ESS interface 1, and assign it to VLAN100.
[AC]interface WLAN-ESS 1
[AC-WLAN-ESS1]port access vlan 100
[AC-WLAN-ESS1]quit
# Configure a WLAN service template with its SSID as multicast and authentication method as
open-system. Bind the WLAN-ESS interface with the service template.
[AC]wlan service-template 1 clear
[AC-wlan-st-1]ssid Multicast
[AC-wlan-st-1]bind WLAN-ESS 1
[AC-wlan-st-1]authentication-method open-system
[AC-wlan-st-1]service-template enable
[AC-wlan-st-1]quit
# Create AP template ap of model WA2100 and configure its serial ID as
210235A29G007C00001.
[AC]wlan ap ap model WA2100
[AC-wlan-ap-ap]serial-id 210235A29G007C00001
# Configure the type of radio 1 of the AP as 802.11g and map the service template to the current
radio.
[AC-wlan-ap-ap]radio 1 type dot11g
[AC-wlan-ap-ap-radio-1]service-template 1
[AC-wlan-ap-ap-radio-1]radio enable
[AC-wlan-ap-ap-radio-1]quit
[AC-wlan-ap-ap]quit
# Enable all radios.
[AC]wlan radio enable all
4. Verify the configuration:
After the configuration is completed, Host A and the client send MLD join messages for group
FF1E::101. Upon receiving the messages, AC sends a join message for the group out port
GigabitEthernet 1/0/1 (a router port) to Router A.
Use the display mld-snooping group command and the display mld group command to display
information about MLD snooping groups and MLD multicast groups. For example:
# Display information about MLD snooping groups on AC.
[AC] display mld-snooping group
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).