H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 70)

61
3. Configure the wireless client to join the IPv6 multicast group:
# Enable MLD snooping in VLAN 100.
[AC] mld-snooping
[AC-mld-snooping]quit
[AC]vlan 100
[AC-vlan100] mld-snooping enable
[AC-vlan100]quit
# Configure GigabitEthernet 1/0/2 as a trunk port and assign it to VLAN 100.
[AC] interface GigabitEthernet 1/0/2
[AC-GigabitEthernet1/0/2] port link-type trunk
[AC-GigabitEthernet1/0/2] port trunk permit vlan 100
[AC-GigabitEthernet1/0/2] quit
# Configure the client to access the WLAN service and request multicast traffic destined for
FF1E::1.
4. Verify the configuration:
# Display detailed MLD snooping group information in VLAN 100 on AC.
[AC]display mld-snooping group vlan 100 verbose
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, A-Aggregation port, C-Copy port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):100.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 1 port(s).
GigabitEthernet1/0/1 (D) ( 00:01:30 )
IP group(s):the following ip group(s) match to one mac group.
IP group address:FF1E::1
(::, FF1E::1):
Attribute: Host Port
Host port(s):total 1 port(s).
WLAN-DBSS1:0 (D) ( 00:04:17 )
MAC group(s):
MAC group address:3333-0000-0101
Host port(s):total 1 port(s).
WLAN-DBSS1:0
The output shows that WLAN-DBSS1:0 on AC joins the IPv6 multicast group FF1E::1.
Configuration procedure (for the WX5000 with LSWM1WCM10 or LSWM1WCM20)
1. Configure WLAN services:
# Log in to the configuration interface of the access controller module from the switch.
oap connect slot 2
Press CTRL+K to quit.
Connected to OAP!