H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 47
38
2.
Use the display this command in IGMP-snooping view or in the corresponding interface view to
verify that the correct multicast group policy has been applied. If not, use the group-policy or
igmp-snooping group-policy command to apply the correct multicast group policy.
3.
Use the display current-configuration command to verify that the function of dropping unknown
multicast data is enabled. If not, use the drop-unknown or igmp-snooping drop-unknown
command to enable the function of dropping unknown multicast data.
4.
Use the display igmp-snooping group command to verify that any port has been configured as a
static member port of any multicast group. If so, check whether this configuration conflicts with the
configured multicast group policy. If any conflict exists, remove the port as a static member of the
multicast group.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points