Igmp snooping proxying configuration example, Network requirements, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 43

34
MAC group(s):
MAC group address:0100-5e01-0101
Host port(s):total 1 port(s).
WLAN-DBSS1:0
The output shows that WLAN-DBSS 1:0 joins the multicast group 224.1.1.1.
IGMP snooping proxying configuration example
Network requirements
As shown in
, Router A connects to a multicast source through port Ethernet 1/2, and to AC
through port Ethernet 1/1. Router A runs IGMPv2 and AC runs IGMPv2 snooping. Router A serves as an
IGMP querier.
Configure IGMP snooping proxying on AC so that AC can forward IGMP reports and leave messages on
behalf of attached hosts, respond to IGMP queries from Router A, and forward the queries to the hosts on
behalf of Router A.
Figure 8 Network diagram
Configuration procedure
1.
Configure an IP address and subnet mask for each interface as per
2.
On Router A, enable IP multicast routing, enable IGMP on Ethernet 1/1, and enable PIM-DM on
each interface.
[RouterA] multicast routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] igmp enable
[RouterA-Ethernet1/1] pim dm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] pim dm
[RouterA-Ethernet1/2] quit
3.
Configure AC:
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points