Configuring multicast group replacement, Configuring multicast group replacement globally, Configuring multicast group replacement on a port – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 28
19
Step Command
Remarks
2.
Enter Layer 2 Ethernet
interface view, Layer 2
aggregate interface view, or
port group view.
•
Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
Use either approach.
3.
Set the maximum number of
multicast groups that a port
can join.
igmp-snooping group-limit limit
[ vlan vlan-list ]
256 by default.
Configuring multicast group replacement
The number of multicast groups that the current AC or a port joins might exceed the upper limit. In
addition, in some specific applications, a multicast group that the AC newly joins must replace an
existing multicast group automatically. A typical example is "channel switching": To view a new channel,
a user switches from the current multicast group to the new one.
To address such situations, enable the multicast group replacement function on the AC or a certain port.
When the number of multicast groups that the AC or the port has joined reaches the limit, one of the
following occurs:
•
If the multicast group replacement feature is not enabled, new IGMP reports are automatically
discarded.
•
If the multicast group replacement feature is enabled, the multicast group that the AC or the port
newly joins automatically replaces an existing multicast group that has the lowest address.
CAUTION:
Be sure to configure the maximum number of multicast groups allowed on a port (see "
maximum number of multicast groups that a port can join
") before enabling multicast group
replacement. Otherwise, the multicast group replacement functionality does not take effect.
Configuring multicast group replacement globally
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter IGMP-snooping view.
igmp-snooping
N/A
3.
Enable multicast group
replacement.
overflow-replace [ vlan vlan-list ] Disabled
by
default
Configuring multicast group replacement on a port
Step Command
Remarks
1.
Enter system view.
system-view
N/A
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points