H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 92)

83
IP group(s):the following ip group(s) match to one mac group.
IP group address:224.1.1.1
(0.0.0.0, 224.1.1.1):
Host port(s):total 1 port.
WLAN-DBSS1:1 (D)
MAC group(s):
MAC group address:0100-5e01-0101
Host port(s):total 1 port.
WLAN-DBSS 1:1
As shown above, IGMP snooping is maintaining the router ports and member ports in VLAN 10.
Port-based multicast VLAN configuration example (for the
WX6000 series)
Network requirements
As shown in Figure 20 , Router connects to a multicast source (the source) through Ethernet 1/1, and to
an access controller through Ethernet 1/2. AC connects to Router through GigabitEthernet 0/0/1, and
to Switch through GigabitEthernet 0/0/2. Switch connects to AC through Ethernet 1/1 and to AP
through Ethernet 1/2.
Create VLAN 10 on AC, assign GigabitEthernet 0/0/1 to VLAN 10, and enable IGMP snooping in the
VLAN. Configure Ten-Gigabitethernet 2/0/1 as a trunk port on AC, and configure it to permit packets
of VLAN 2, VLAN 3, and VLAN 10 to pass. IGMPv2 is running between Router and AC, and IGMPv2
snooping is running on AC, with Router acting as the IGMP querier.
Create WLAN-ESS 1 on AC and configure it as a hybrid port with VLAN 10 as the default VLAN.
Configure the port to permit packets from VLAN 2, VLAN 3, and VLAN 10 to pass. Configure the
MAC-based VLAN feature so that Client A and Client B belong to VLAN 2 and VLAN 3 respectively.
Create VLAN 2, VLAN 3, and VLAN 10 on Switch, and enable IGMP snooping in these VLANs.
Configure Ethernet 1/1 and Ethernet 1/3 as trunk ports, and configure them to allow packets of VLAN
2, VLAN 3, and VLAN 10 to pass.
The multicast source sends multicast data to multicast group 224.1.1.1. Client A and Client B belong to
VLAN 2 and VLAN 3 respectively and they are receivers of the multicast group.
Configure the port-based multicast VLAN feature so that Router can send multicast data to the receivers
connecting with the access controller through the multicast VLAN.