Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 108
99
Figure 25 Network diagram
Configuration procedure
1.
Enable IPv6 forwarding on each AC and configure the IPv6 address and address prefix for each
interface as per
. (Details not shown.)
2.
On Router, enable IPv6 multicast routing, enable IPv6 PIM-DM on each interface, and enable MLD
on the host-side interface Ethernet 1/2.
[Router] multicast ipv6 routing-enable
[Router] interface ethernet 1/1
[Router-Ethernet1/1] pim ipv6 dm
[Router-Ethernet1/1] quit
[Router] interface ethernet 1/2
[Router-Ethernet1/2] pim ipv6 dm
[Router-Ethernet1/2] mld enable
[Router-Ethernet1/2] quit
3.
Configure AC:
# Enable MLD snooping globally.
[AC] mld-snooping
[AC-mld-snooping] quit
# Create VLAN 10, assign Ten-GigabitEthernet 2/0/1 to VLAN 10, and enable MLD snooping in
this VLAN.
[AC] vlan 10
[AC-vlan10] port Ten-GigabitEthernet 2/0/1
[AC-vlan10] mld-snooping enable
[AC-vlan10] quit
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points