H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 57)

48
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter Layer 2 Ethernet
interface view, Layer 2
aggregate interface view, or
port group view.
• Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view:
interface interface-type
interface-number
• Enter port group view:
port-group manual
port-group-name
Use either approach.
3. Configure the port as a static
member port.
mld-snooping static-group
ipv6-group-address [ source-ip
ipv6-source-address ] vlan vlan-id
No static member ports by default.
4. Configure the port as a static
router port. mld-snooping static-router-port
vlan vlan-id
No static router ports by default.
Configuring simulated joining
Generally, an MLD-enabled host can responds to MLD queries that the MLD querier sends. If a host fails
to respond, the multicast router deems that no member of this IPv6 multicast group exists on the network
segment, and removes the corresponding forwarding path.
To avoid this situation, you can enable simulated joining on a port of the access controller. Namely, you
configure the port as a simulated member host for an IPv6 multicast group. When the simulated member
host receives an MLD query, it gives a response. Therefore, the access controller can continue receiving
IPv6 multicast data.
A simulated host acts like a real host in the following ways:
• When a port is configured as a simulated member host, the access controller sends an unsolicited
MLD report through the port, and can respond to MLD general queries with MLD reports through the
port.
• When the simulated joining function is disabled on a port, the access controller sends an MLD done
message through that port.
To configure simulated joining:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter Layer 2 Ethernet
interface view, Layer 2
aggregate interface view, or
port group view.
• Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view:
interface interface-type
interface-number
Use either approach.
• Enter port group view:
port-group manual
port-group-name
3. Configure simulated joining.
mld-snooping host-join
ipv6-group-address [ source-ip
ipv6-source-address ] vlan vlan-id Not configured by default.