Configuration procedure (for the wx5004), Figure 13 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 69
60
Figure 13 Network diagram
Configuration procedure (for the WX5004)
1.
Enable IPv6 PIM-DM and MLD on the port of Router A that connects to AC, and enable IPv6
multicast routing globally.
2.
Configure WLAN services:
# Configure the WLAN-ESS interface and assign WLAN ESS 1 to VLAN 100.
[AC]Vlan 100
[AC-vlan100]quit
[AC]interface WLAN-ESS 1
[AC-WLAN-ESS1]port access vlan 100
[AC-WLAN-ESS1]quit
# Configure a WLAN service template with its SSID as multicast and authentication method as
open-system. Bind the WLAN-ESS interface with the service template.
[AC]wlan service-template 1 clear
[AC-wlan-st-1]ssid Multicast
[AC-wlan-st-1]bind WLAN-ESS 1
[AC-wlan-st-1]authentication-method open-system
[AC-wlan-st-1]service-template enable
[AC-wlan-st-1]quit
# Create AP template ap of model WA2100 and configure its serial ID as
210235A29G007C00001.
[AC]wlan ap ap model WA2100
[AC-wlan-ap-ap]serial-id 210235A29G007C00001
# Configure the type of radio 1 of the AP as 802.11g and map the service template to the current
radio.
[AC-wlan-ap-ap]radio 1 type dot11g
[AC-wlan-ap-ap-radio-1]service-template 1
[AC-wlan-ap-ap-radio-1]radio enable
[AC-wlan-ap-ap-radio-1]quit
[AC-wlan-ap-ap]quit
# Enable all radios.
[AC]wlan radio enable all
Router A
Source
AC
GE 1/0/1
GE 1/0/2
IPv6 Multicast Packets
AP
Client
Switch
WLAN-ESS1
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points