H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 97)

88
Total 1 multicast-vlan(s)
Multicast vlan 10
port list:
WLAN-ESS1
# View the IGMP snooping multicast group information on the access controller.
[AC] display igmp-snooping group
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, A-Aggregation port, C-Copy port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):10.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 0 port.
IP group(s):the following ip group(s) match to one mac group.
IP group address:224.1.1.1
(0.0.0.0, 224.1.1.1):
Host port(s):total 1 port.
WLAN-DBSS1:1 (D)
MAC group(s):
MAC group address:0100-5e01-0101
Host port(s):total 1 port.
WLAN-DBSS1:1
As shown above, IGMP snooping is maintaining the router ports and member ports in VLAN 10.
Port-based multicast VLAN configuration example (for the
WX3024E)
Network requirements
Router connects to a multicast source (the source) through Ethernet 1/1, and to an access controller
through Ethernet 1/2. AC connects to Router through GigabitEthernet 1/0/1, and to AP through
GigabitEthernet 1/0/2. IGMPv2 is running between Router and AC, and IGMPv2 snooping is running
on AC, with Router acting as the IGMP querier.
Create VLAN 10 on AC, assign GigabitEthernet 1/0/1 to VLAN 10, and enable IGMP snooping in the
VLAN. Configure GigabitEthernet 1/0/2 as a hybrid port, and configure the port to permit packets from
VLAN 2, VLAN 3, and VLAN 10 to pass. Configure aggregate port BAGG 1 as a trunk port, and
configure the port to permit packets from VLAN 2, VLAN 3, and VLAN 10 to pass.
Create WLAN-ESS 1 on AC and configure it as a hybrid port with VLAN 10 as the default VLAN.
Configure the port to permit packets from VLAN 2, VLAN 3, and VLAN 10 to pass. Configure the
MAC-based VLAN feature so that Client A and Client B belong to VLAN 2 and VLAN 3 respectively.