Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 93
84
Figure 20 Network diagram
Configuration procedure
1.
Configure the IP address and subnet mask for each interface as per
. (Details not shown.)
2.
On Router, enable IP multicast routing, enable PIM-DM on each interface, and enable IGMP on the
AC-side interface Ethernet 1/2.
[Router] multicast routing-enable
[Router] interface ethernet 1/1
[Router-Ethernet1/1] pim dm
[Router-Ethernet1/1] quit
[Router] interface ethernet 1/2
[Router-Ethernet1/2] pim dm
[Router-Ethernet1/2] igmp enable
[Router-Ethernet1/2]quit
3.
Configure AC (for WX6103):
# On the configuration interface of the WX6103 AC main control board, enable IGMP snooping
globally.
[AC] igmp-snooping
[AC-igmp-snooping] quit
# Create VLAN 10, and enable IGMP snooping in this VLAN.
[AC] vlan 10
[AC-vlan10] igmp-snooping enable
[AC-vlan10] quit
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points