Configuring user port attributes, Configuring ipv6 multicast vlan ports, Configuration guidelines – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 103: Configuration procedure

94
•
Enable MLD snooping in all the user VLANs.
Configuring user port attributes
Configure the user ports as hybrid ports to permit packets of the specified user VLAN to pass and
configure the user VLAN to which the user ports belong as the default VLAN.
Configure the user ports to permit packets of the IPv6 multicast VLAN to pass and untag the packets. Thus,
after receiving multicast packets tagged with the IPv6 multicast VLAN ID from the upstream device, the
Layer 2 device untags the multicast packets and forwards them to its downstream device.
To configure user port attributes:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter Ethernet interface view
or port group view.
•
Enter Ethernet interface view
interface interface-type
interface-number
•
Enter port group view
port-group manual
port-group-name
Use either command.
3.
Configure the user port link
type as hybrid.
port link-type hybrid
Access by default.
4.
Specify the default VLAN for
the hybrid port.
port hybrid pvid vlan vlan-id
VLAN 1 by default.
5.
Configure the hybrid port to
allow packets from specified
VLANs to pass.
port hybrid vlan vlan-id-list
{ tagged | untagged }
By default, a hybrid port permits
only packets of VLAN 1 to pass.
NOTE:
Configurations made in Ethernet interface view are effective only on the current port. Configurations made
in port group view are effective on all ports in the current port group.
For more information about the port link-type, port hybrid pvid vlan, and port hybrid vlan commands,
see Layer 2 Command Reference.
Configuring IPv6 multicast VLAN ports
In this approach, configure a particular VLAN as an IPv6 multicast VLAN and assign user ports to this
IPv6 multicast VLAN.
Configuration guidelines
•
You cannot configure IPv6 multicast VLAN on a device with multicast routing enabled.
•
The VLAN to be configured as an IPv6 multicast VLAN must exist.
•
A port can belong to only one IPv6 multicast VLAN.
Configuration procedure
To configure IPv6 multicast VLAN ports in IPv6 multicast VLAN view:
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points