Westermo MRI-128-F4G-PSE24 - Manual (Page 38)

34
Request packet.
Helper Address: Type the IP address of the target DHCP Server. There are 4
available IP addresses.
4.2.7 Backup and Restore
With Backup command, you can save current configuration file saved in the
switch’s flash to admin PC or TFTP server. This will allow you to go to Restore
command later to restore the configuration file back to the switch. Before you
restore the configuration file, you must place the backup configuration file in the
PC or TFTP server. The switch will then download this file back to the flash.
There are 2 modes for users to backup/restore the configuration file, Local File
mode and TFTP Server mode.
Local File mode: In this mode, the switch acts as the file server. Users can browse
the target folder and then type the file name to backup the configuration. Users
can also browse the target folder and select existed configuration file to restore
the configuration back to the switch. This mode is only provided by Web UI while
CLI is not supported.
TFTP Server mode: In this mode, the switch acts as TFTP client. Before you do so,
make sure that your TFTP server is ready. Then please type the IP address of TFTP
Server and Backup configuration file name. This mode can be used in both CLI
and Web UI.
TFTP Server IP Address: You need to key in the IP address of your TFTP Server
here.
Backup/Restore File Name: Please type the correct file name of the
configuration file.
Configuration File: The configuration file of the switch is a pure text file. You can
open it by word/txt read file. You can also modify the file, add/remove the
configuration settings, and then restore back to the switch.
Startup Configuration File: After you saved the running-config to flash, the new
settings will be kept and work after power cycle. You can use show startup-config
to view it in CLI. The Backup command can only backup such configuration file to
your PC or TFTP server.