Westermo MRI-128-F4G-PSE24 User Manual
Page 147
143
Remote Mode: In this mode, you should assign the IP address of the System Log
server. The switch will send the occurred events selected in Event Selection page
to System Log server you assigned.
Both: Both modes can be enabled at the same time.
Once you finish configuring the settings, click on Apply to apply your
configuration.
Note: When enabling Local or Both modes, you can monitor the system logs in
[Monitor and Diag] / [Event Log] page.
4.12.4 SMTP Configuration
The switch supports E-mail Warning feature. The switch will send the occurred
events to remote E-mail server. The receiver can then receive notification by
E-mail. The E-mail warning is conformed to SMTP standard.
This page allows you to enable E-mail Alert, assign the SMTP Server IP, Sender
E-mail, and Receiver E-mail. If SMTP server requests you to authorize first, you
can also set up the username and password in this page.