Westermo MRI-128-F4G-PSE24 - Manual (Page 105)

101
Switch(config-if)# no ip address 192.168.2.200/24
->Delete the IP address
Create multiple
VLANs (VLAN 5-10)
Switch(config)# interface vlan 5-10
Shut down VLAN Switch(config)# interface vlan 2
Switch(config-if)# shutdown
Switch(config-if)# no shutdown ->Turn on the VLAN
Display – VLAN table Switch# sh vlan
VLAN Name Status Trunk Ports Access Ports
---- --------- --------- ----------------- -------------------
1 VLAN1 Static - fa1-7,gi25-27
2 VLAN2 Unused - -
3 test Static fa4-7,gi25-27 fa1-3,fa7,gi25-27
Display – VLAN
interface information Switch# show interface vlan1
interface vlan1 is up, line protocol detection is disabled
index 14 metric 1 mtu 1500
HWaddr: 00:07:7c:ff:01:b0
inet 192.168.2.200/24 broadcast 192.168.2.255
input packets 639, bytes 38248, dropped 0,
multicast packets 0
input errors 0, length 0, overrun 0, CRC 0, frame
0, fifo 0, missed 0
output packets 959, bytes 829280, dropped 0
output errors 0, aborted 0, carrier 0, fifo 0,
heartbeat 0, window 0
collisions 0
GVRP configuration
GVRP enable/disable Switch(config)# gvrp mode
disable Disable GVRP feature globally on the
switch
enable Enable GVRP feature globally on the
switch
Switch(config)# gvrp mode enable
Gvrp is enabled on the switch!
Configure GVRP Switch(config)# inter fa1