Westermo MRI-128-F4G-PSE24 - Manual (Page 145)

141
not ping target device until Hold Time is timeout.
Event Type: Super Ring Failure
Select Super Ring Failure. When the Rapid Super Ring topology is changed, the
system will short Relay Out and lengthen Alarm LED.
Once you finish configuring the settings, click on Apply to apply your
configuration.
4.12.2 Event Selection
Event Types can be divided into two basic groups: System Events and Port Events.
System Events are related to the overall function of the switch, whereas Port
Events related to the activity of specific ports
System Event Warning Event is sent when…..
Device Cold Start Power is cut off and then reconnected.
Device Warm Start Reboot the device by CLI or Web UI.
Authentication
failure
An incorrect password, SNMP Community
String is entered .
Time Synchronize
Failure
Accessing to NTP Server is failure.
Fault Relay The DO/Fault Relay is on.
Super Ring Topology
Changes
Master of Super Ring has changed or backup
path is activated.
SFP DDM Failure The readed information of DDM SFP
transceiver is over temperature or out the
range of TX/RX power.
Power Failure Power (AC, DC1, DC2 or Any) is failure.
Port Event Warning Event is sent when…..
Link-Up The port is connected to another device
Link-Down The port is disconnected (e.g. the cable is
pulled out, or the opposing devices turns